Insert a new battery. The plus contact of the battery (marked with a +) must face downwards on type 1 and passive key and upwards on type 2. Reassembling the container. Snap the two halves of the housing together. Remote control type 1. Assemble the key blade until it snaps onto the container. Remote control type 2.
The Ford Focus instrument cluster can be put into a test mode, displaying diagnostic information. Have a newer Focus? Check out the instructions for test mode on the Mk3! Time Required: Less than 5 Minutes. Tools Needed: none required. Procedure: (information found on the internet and in the 2001 Ford Cars Service manual on CD-ROM)
MAXI - 8x2Ghz processzor, 8GB/128GB, DTS, DSP, RDS, SIM, Optikai, 2000x1200 QLED, Mesterséges intelligencia [+180.000 Ft]-Ford Focus MK2 MK3 (2004-2011) 9" magyar menüs GPS Android autórádió gyári helyére (manuális klímáshoz) mennyiség +
Right behind the glove box (folds down) 1. lower the glove compartment. 2. disconnect the blower motor resistor electrical connector. 3. detach and remove the blower motor resistor. Remove it from the housing by sliding the resistor to the right and lift upward. 4. Lista functiilor meniului ascuns : 1 Needle sweep / gauges test.2 LCD segments test. 3 LED test.4 ROM level.5 NVM target ROM.6 NVM EEPROM LVL.7 Manufacture s Posted September 13, 2014. Hi folks, I'm part-way through a front-end (mainly nearside) rebuild of a Mk2 Focus. (I'm not a mechanic. I'm just having a go.) I've just installed a new ECM housing box. Looking at the catalogue (I think taken from FordCat) there's another part - 9F721 in the attached diagram.
